论文部分内容阅读
现浇无缝塑料地面是一种新型地面,它是以聚酯酸乙烯乳液为胶结料,以细砂和石英粉为骨料,在现场浇铺而成的。无缝塑料地面的总厚度一般为4毫米,最厚不超过7毫米,一般做在水泥砂浆面层上。通过湖光仪器厂某洁净车间7年的使用证明,这种地面与水磨石、玻璃、木板的粘结力很强,弹性好,既能防尘(达到100级的要求),又能避免由于静电而产生吸尘现象。因此这种地面宜于在防尘要求高的车间和房间中推广使用。无缝塑料地面的构造如图1所示。
The cast-in-place seamless plastic floor is a new kind of ground, which is made of polyester-polyester emulsion as a binder, fine sand and quartz powder as aggregate, and is cast on site. The total thickness of a seamless plastic floor is generally 4 mm, and the maximum thickness is not more than 7 mm. It is generally made on the surface of cement mortar. The use of a cleanroom in Huguang Instrument Factory for 7 years has proved that this type of ground has strong adhesion to terrazzo, glass and wood, good elasticity, and can be dust-proof (up to Class 100 requirements) while avoiding static electricity. Dust generation occurs. Therefore, this kind of ground should be popularized in workshops and rooms where dustproof requirements are high. The construction of a seamless plastic floor is shown in Figure 1.